GETECH Automation Pte Ltd

Products PCB Stand-Alone Routers PCB Inline Routers End of Line Automation Epson

GETECH SERVICE CENTER
All our agents are trained to perform routine service procedures to the complete range of machines on-site and will make recommendations as to particular requirements.

Getech will try and complete all overhauls for major components on the standard range of routing machines e.g spindles, within a 48 hour period.

TRAINING COURSE
To ensure maximum usage of the your machine, whether it be a PCB router, an End of Line automated machine or a customized machines, proper training, both service and operation is essential.

Getech offers in-house or on-site training for all levels of use.

For the PCB routers we have a range of standard training programs, based around the recommended pass word level entry set on the machine:

Machine Safety and Operation	No password entry This course is aimed at the operator and covers all aspects of machine safety, basic machine maintenance, and operation of machine Duration approximately ½ day

Machine Programming and Setup (Basic)	Technician password entry This course is aimed at the technician responsible for fixturing design and set up, program writing and editing, and allows access to adjust manipulator speeds Duration approximately 1 day

Installation and Service (Advance)	Engineer password entry This course is aimed at the engineer, responsible for machine settings including camera and spindle offsets Duration approximately 1/2 days

Installation and Service (Service)	Service password entry Full service access, Robot motion control Duration approximately 3 days

Each of the courses are taught by qualified Getech engineers, who at the end of the training will issue a certificate to participants.

Top

Products